Learn more
To make this fall hoop wreath you need a hoop, florals, ribbon, & hot glue.
Full supply list & tutorial here
First spray paint your hoop wreath & your metal word. I used "thankful."
Get the tutorial here!
Hot glue the end of your ribbon to the "l" on "thankful."
Get the full tutorial here!
Measure out the ribbon so that the word hangs in the center of the hoop wreath. Loop the ribbon over the hoop then cut it to fit.
Full tutorial here
Glue the ribbon to the word so that it hangs in the center of the hoop wreath.
Full tutorial w/ video here!
Cut pieces of eucalyptus off to place on your fall hoop wreath.
Get the tutorial & video here!
Attach them to the hoop wreath either at the top, bottom, or one of the sides. I chose the left side.
Full step-by-step tutorial here!
Next trim off your other fall florals. I used peonies & hydrangeas & placed them inside each other.
Get the full tutorial here!
Hot glue pipe cleaners or floral wire to them to attach to the hoop wreath.
Full tutorial here w/ video here!
I also attached the flowers together with pipe cleaners.
Get the video full tutorial here!
Finally, attach your fall flowers to the hoop wreath in between the eucalyptus.
Full tutorial here
It turned out so elegant & gorgeous! Get the full tutorial with video & other matching tutorials on the blog!
Get the full tutorial here!
Head over & pin the tutorial for later! Follow me on Pinterest for new ideas daily!
Pin the tutorial here!